Home  »  Tech Support

Aprimatic remote manual

Aprimatic Garage door remote 


Programming with a programmed remote :

1. Approach your installation up to 1 meter.
2. Press simultaneously on all buttons of the programmed remote until the receiver emits acontinuous audio signal.
3. While you hear the sound, press simultaneously all buttons on the new remote control. Thesound stops and starts again. Release the buttons.
4. Press a button on the new remote. The sound stops and starts again. Release the button.
5. Wait 10 seconds. The sound goes out.
6. Your new remote control is programmed.

Programming with the receiver:
This method works only with the first remote to be registered. Once a remote is registered, you mustregister remote to remote (see programming with a programmed remote).


1. Turn on the power at the receiver. 10 beeps will follow.
2. Press all buttons of your new remote until the receiver emits a continuous audio signal to.
3. While you hear the sound, press any button on the new remote. The sound stops and startsagain. Release the button.
4. Wait for 10 seconds. The sound goes out.
5. Your new remote control is programmed.