Home  »  Tech Support

Avidsen remote manual

Avidsen remote manual

AVIDSEN 104250 – 104251 - 104257 - 610955

There are several different types of receivers.

Programming of your new remote control

1st type of receiver:

1. Open the casing of your receiver. It is located next to your motor.
2. On the receiver board, press the programing button (RF). Hold it pressed. The LED (L1) of thereceiver goes out. Release the button.
3. In the next 10 seconds, press a button on your new remote. Hold it. The LED on the receiverstarts to flash. Release the button.
4. Wait 10 seconds.5. Your new remote is programmed.


2nd type of receiver:



1. Open the casing of your receiver. It is located next to your motor.
2. On the receiver circuit board, press the programming button (RX). Let the button go. Thereceiver LED light illuminates. Wait 5 seconds. The receiver LED light turns off.
3. Press a button on your new remote control. Keep it pressed down. The receiver LED lightilluminates. Let the button go.
4. Wait 10 seconds.
5. Your new remote control is programmed.